Quick Installation Guide
NS-B4111 CD Boombox
Read these instructions carefully before using this product, and retain
them in a safe place for reference.
Front
Setting the clock
1 Turn off your CD player, then press
TIME SET. The hour digits flash. Set
time under Standby mode.
Features
Top
2 Press
or
to adjust the hour,
then press TIME SET. The minute
digits flash.
3 Press
or
to adjust the minute,
then press TIME SET. The clock is set.
4 To view the clock, turn on your CD
player, then press DISPLAY.
NOTE: While the boombox is in standby mode running on battery
power, your batteries will continue to slowly drain, although
the clock’s time will be saved. To prevent battery drain, turn the
boombox completely off by sliding the power switch (although
your clock setting will be lost).
1
2
3
4
5
6
7
Speaker
8
9
Speaker
CD play/pause button
CD stop button
Time set button
1
2
3
4
Handle
5
6
7
8
Function (RADIO/CD/AUX)
Power (ON/OFF)
10 Display button
11 Repeat button
12 Random button
13 Standby button
CD door
CD skip next button
CD track display
Volume control
FM antenna
Tuning control
Using your CD player
Warning: Use of any controls, adjustments, or procedures other
than those specified herein may result in hazardous radiation
exposure.
CD door open (push tab)
CD skip previous button
AM/FM button
Back
Using the radio
1 Slide the FUNCTION selector to RADIO, then press AM/FM to
select AM or FM mode.
Setting up your CD player
Connecting AC power
1 Connect the provided AC power cord to the AC input socket on
2 Turn the TUNING control until you locate the station you want.
If you tune to an FM station broadcasting in stereo, the stereo
indicator turns on.“ST”will appear in the upper-right of the LCD
screen when stereo is on.
the CD player.
2 Plug the cord into a household AC power socket.
Installing batteries
•
For optimum FM reception, make sure that the FM
(telescopic) antenna is fully extended and vertical.
1 Insert eight C alkaline batteries (not included) into the battery
compartment as indicated by the diagram within the
compartment.
-
+
-
-
+
-
+
-
+
-
+
-
+
-
1.5V x 8 UM 2 or
“C” size or LR14
•
For optimum AM reception, rotate the CD player to orient its
built-in antenna until you get the strongest signal.
2 Securely close the battery compartment cover.
+
+
Using the CD player
The CD player can play standard audio CDs and audio CDs created
on a computer’s CD-R/CD-RW drive.
1 Slide the FUNCTION selector to CD, then lift the CD door and
insert a CD with the label facing up. Make sure that the CD is
correctly mounted on the spindle and locked in place.
Notes: Battery power is used only when AC power is disconnected.
Replace all batteries at the same time with the same battery type.
Do not mix battery types.
When CD player is stored unused for a long time, remove the
batteries to prevent damage.
1
2
3
AUX IN jack
Battery compartment
AC input
NS-B4111_09-0103_QSG_V2_EN.indd
1
3/4/2009 7:57:12 PM
|